SolidSense OEM software image
- SolidRun
- Yazan Shhady
- Ron Vaknin (Unlicensed)
- Kareiman Fadly (Unlicensed)
The documentation for SolidSense software is not maintained by SolidRun and the information herein is not actual with the latest version of the software, please contact our partner SolidSense Connect who is now developing the SolidSense software.
Here is the Solidsense-Connect WiKi documentation page.
Introduction
The SolidSense OEM software image is the easiest solution to start a development on the SolidSense hardware. This is allowing to freely use all Debian Linux resources. The image comes with all SolidSense interfaces declared in the device tree as well all associated drivers.
The resulting development can then be directly used or re-package to run on top of the SolidSense IoT production platform that is providing key production features like read-only rootfs for safety and remote software management.
Installation
Step-By-Step
Download the image and flash on a USB stick with a tool like Etcher.
Open the top cover of your device by removing the 6 x screws.
Connect a TTL UART cable and open a serial connection console. You can refer to serial connection for installing the necessary serial connection software.
Stop booting in U-Boot and run the commands below - only at the first boot :
setenv bootcmd "env run findfdt; usb start; ls usb 0:1; run bootcmd_usb0; run bootcmd_mmc0; $bootcmd"; saveenv; boot
You can always run env default -a -f; saveenv; reset to recover the default status.
Please Note:
The boot priority is:
USB (if any compatible image is found)
SD (if any compatible image is found)
emmc (booting the default Solidsense SW)
Then you’ll see the following:
In order to be able to log in, please insert
solidsenseas a username and password as follows:
Related pages
SolidRun Ltd.