/
Building OpenOCD for i.MX Platforms

Building OpenOCD for i.MX Platforms

Compiling OpenOCD For SolidRun iMX* Based Products

The purpose of this document is to cover compiling OpenOCD directly on the developer board specifically for using OpenOCD to flash connected devices via the imx_gpio interface. We will use Debian as the base for the instructions, however the general procedure should work with slight modification on most distributions. Cross-compiling is possible but is currently not in the scope of this document.

Prepare Debian for compiling

Start by making sure Debian is updated to the latest version.

Next, run the following command to install all the tools needed to build OpenOCD from source

sudo apt install build-essential git autoconf libtool make pkg-config libusb-1.0-0 libusb-1.0-0-dev

Get the Source and Compile OpenOCD

Once that has finished clone the SolidRun github repository, as it has patches to mainline OpenOCD specifically for the new iMX8M AARCH64 architecture. Then bootstrap, configure and build the source.

git clone https://github.com/SolidRun/openocd.git cd openocd ./bootstrap ./configure --prefix=/usr --sysconfdir=/etc --enable-imx_gpio --enable-sysfsgpio --disable-stlink --disable-ti-icdi --disable-ulink --disable-usb-blaster-2 --disable-vsllink --disable-xds110 --disable-osbdm --disable-opendous --disable-aice --disable-usbprog --disable-rlink --disable-armjtagew --disable-cmsis-dap --disable-kitprog --disable-usb-blaster --disable-presto --disable-openjtag --disable-jlink make

This configures and builds OpenOCD for a very limited purpose built build mainly targeted at using the imx_gpio interface.

Finally install the source

sudo make install

Great now OpenOCD is ready to use.

Related content

Building Newt Nimble BLEHCI firmware for the iMX8MQ NINA-B1 Module
Building Newt Nimble BLEHCI firmware for the iMX8MQ NINA-B1 Module
More like this
Boot from USB OTG - i.MX8M
Boot from USB OTG - i.MX8M
More like this
eFuses for i.MX8M Mini SOM
eFuses for i.MX8M Mini SOM
More like this
SPI from Linux with spidev
SPI from Linux with spidev
Read with this
i.MX6 Kernel
i.MX6 Kernel
More like this
i.MX8M Ethernet MAC Address Fusing
i.MX8M Ethernet MAC Address Fusing
Read with this

SolidRun Ltd.