You will need to download an operating system for the ClearFog GT-8K and flash in to a blank SD card in order to use the system. You can download official release distributions and find flashing instructions at our ClearFog GT 8K Quick Start Guide page. If you need help to flash the SD card please see our article Flashing an SD Card .
Before powering up the board for the first time it is recommended to select the boot media. The boot source is selected by setting SW6 (on the print side) to the right mode. The following modes are available:
Boot Source | Position | Position | Position | Position | Position |
SPI ROM | OFF | OFF | ON | OFF | OFF |
SD Card | ON | ON | OFF | ON | OFF |
eMMC | ON | ON | ON | OFF | OFF |