...
| Tip |
|---|
Please Note For more information about the antennas used (optional) with the SolidSense N6 indoor please see this article : SolidSense N6 Indoor Kits |
The assembly of the u.FL to SMA cables can be seen in the picture below;
...
SolidSense uses PN B50(15-02)G8-09-A023-B52 by BTOP : http://www.magnetic-rj45jack.com/sale-10691195-bicolor-led-rj45-connector-port-high-performance-for-maximum-emi-suppression.html
Please Note
Due to internal i.MX6 buses the 1000Mbps interface speed is limited to 470Mbps.
...
Please refer to this article for more information : i.MX6 Application Note – Suspend to Memory Power Measurements
Bottom lid
Mechanical files of the bottom lid as well as the top and bottom cover can be seen here : https://developer.solid-run.com/download/solidsense-n6-indoor-enclosure-assembly/ <TBD>
The bottom lid purpose is to allow easy access to the replace / install the SIM card without having to open all of the box.
The system can be used in 4 ways
...
For managing your IoT gateway, monitor the gateway status, and manage the network configuration, you can refer to Configuring SolidSense networking with Kura .
Please see below picture to get the serial number for SSID of the network.
...
If you are using SolidSense as a Wirepas gateway you can directly configure your Wirepas gateway by referring to Configuring and testing the Wirepas gateway software .
For flashing or re-flashing Wirepas sinks, please refer to Flashing or Re-flashing Wirepas sinks on SolidSense gateway (V0.9 and up) .
...
| Code Block |
|---|
l2ping -c 4 $MAC |
Support
Please follow our SolidSense Support Overview page.
Documentation
| Attachments | ||||
|---|---|---|---|---|
|
...