...
Introduction
The following quick start guide provides background information about the SolidRun Hailo 15 SOM.
...
Date | Owner | Revision | Notes | ||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Mikhail Anikin | 1.0 | Initial release | |||||||||||||||||||||||
Mikhail Anikin | 1.1 | Update flashing process | |||||||||||||||||||||||
Mikhail Anikin | 1.2 | Add IIoT support | |||||||||||||||||||||||
Table of Contents |
| ||||||||||||||||||||||||
...
Boot select and boot options
...
You should select the boot source before powering up the board for the first time.
Hailo 15 with HummingBoard has two boot options: serial boot (for recovery) and eMMC boot (the main option). To select a boot option, the DIP switch needs to be modified.
For more information, see HummingBoard Hailo 15 Boot Select
Generating Yocto image
The prebuilt artifacts are available here.
...
| Code Block |
|---|
python3 -m pip install hailo15_board_tools-1.2.1-py3-none-any.whl |
Set the S3 switch to the Serial download mode:
...
1
...
2
...
3
...
4
...
5
...
6
...
off
...
on
...
off
...
off
...
off
...
.
Close the serial terminal on your PC.
Reset the board.
Upload the uart flashing firmware into the SOM:
...
Find the line spl_boot_source=mmc2 and replace it with spl_boot_source=uart in the file u-boot-initial-env-uart.
Set the S3 switch to the Serial download mode:
...
1
...
2
...
3
...
4
...
5
...
6
...
off
...
on
...
off
...
off
...
off
...
off
.
Close the serial terminal on your PC.
Reset the board.
Upload the uart flashing firmware into the SOM:
...
Set the S3 switch back to the normal boot:
...
1
...
2
...
3
...
4
...
5
...
6
...
off
...
off
...
off
...
off
...
off
...
off
Open the serial connection and reset the boot. The board will boot to the SPL and expect the u-boot image to be transferred over the serial.
...
If you previously modified a u-boot env to force a serial mode, you need to restore it.
Set the S3 switch to the Serial download mode:
...
1
...
2
...
3
...
4
...
5
...
6
...
off
...
on
...
off
...
off
...
off
...
.
Close the serial terminal on your PC.
Reset the board.
Upload the uart flashing firmware into the SOM:
...
Set the S3 switch back to the normal eMMC boot:
...
1
...
2
...
3
...
4
...
5
...
6
...
off
...
off
...
off
...
off
...
off
...
Open the serial connection and reset the boot. The board will boot to the SPL and expect the u-boot image to be transferred over the serial.
...