Page Comparison

...

• PFsense 2.7 community

• Note: versions below 2.7 do not have drivers for intel nics and SFP

• Terminal software:

  • Putty

  • Alternatively, Tio can also be used.
    known TIO limitation: in BIOS, the currently selected option is displayed in the same color as the background, which makes it not visible, yet it is still fully functional.

• USB flash disk: Kingston Data Traveler

...

Please follow instructions at Using serial console with Bedrock V3000

BIOS settings

...

• Insert the USB media to the device

• Turn on Bedrock

• Repetitively press the DEL / ESC key to enter the BIOS setup

• In BIOS go to -> Save & Exit -> <your bootable USB device> -> yes

• Device will reset and a grub PFsense boot screen will appear

After boot

...

• Press "esc" or the arrow buttons to go to the boot option shell 

• Set the console redirection (copy to the terminal): 

  • Code Block
    set hw.uart.console="mm:0xfedc9000,rs:2"

    • NOTE: on older versions, the line you paste might look a little weird especially if you type it manually
      example for copy: /K |et hw.uart.console="mm:0xfedc9000,rs:2" 
      example for manual type: \e|/-\|/r-\co|sol/-\|m:/x-ed\9|0/-\|:/" 
      THIS IS FINE AS LONG AS THE ACTUAL TEXT WAS TYPED CORRECTLY

  Type boot 

• Now run:

  • Code Block
    boot

• You will be prompted with a console type selection, tested on console type vt100

  • NOTE: (it’s the default option so you can just press enter) 

• Accept copyright and distribution notice 

  

• Choose Install pfSense

  

...

• Wait until the installation is complete 

  

• Select yes because we will need to make the following modifications to enable console: 

  • Create the /boot/loader.conf.local file, which will contain our changes , file and add: 

    • hw.uart.console="mm:0xfedc9000,rs:2" 

    • console="efi" 

    • Note: /boot/loader.conf recreates itself each boot or update, so this will override the changes. 

  • If you also don’t want to see the boot log, also add: 

    • boot_mute="YES"  

• When done type "exit" and reboot the system

...