...
| Info |
|---|
Supported with RZ/G2LC SOM. For more detailed information about our SOM-RZ/G2LC series please visit this user manual : RZ/G2LC SOM Hardware User Manual . |
Block Diagram
The following figure describes the RZ/G2LC Block Diagram.
...
The following shows how to set the switches on the boot source selector:
...
| Info |
|---|
Please Note: The black rectangle represents the switch position. |
...
Downloading the image
Download the image (for example Debian) by running the following command on your Linux/Windows PC:Code Block wget https://solid-run-images.sos-de-fra-1.exo.io/RZ/Debian/rzg2lc_build/20231122-6391518build_date_20240529-git_rev_f22483f/rzg2lc-solidrun-sd-emmc-debian-6391518f22483f.img.xz
For more Debian releases, please visit Debian Releases for RZ/G2LC.
Writing the image to the SD card
Use the following commands for writing the image to an SD card:Code Block xz -dc rzg2lc-solidrun-sd-emmc-debian-6391518f22483f.img.xz | dd of=/dev/sdX bs=4k conv=fdatasync
For more information, please visit Flashing an SD Card .
Note:Plug a micro SD into your Linux PC, the following assumes that the USB-Disk / Micro-SD is added as /dev/sdX and all it’s partitions are unmounted.
Note: You can use the following command for writing to the SD in case you generated your own image:
Code Block $ sudo dd if=/your/image/path of=/dev/sdX bs=4k conv=fdatasync
SD card insertion
Please Insert the SD card into your device.Power connection
Connect your power adaptor to the DC jack, and then connect the adaptor to mains supply.Power On
Hold on the On/Off Power button - SW1 (as shown in the figure below)
Note: The system should turn on by default when the power is connected (without pressing the button).
Serial Connection
Please insert the micro USB into your device, then you can refer to Serial Connection for installing necessary serial connection software in Linux/Windows.
Once you installed the necessary serial connection software, you should be able to see the following:
...