Page Comparison

Introduction

The following quick start guide provides background information about the HummingBoard Pro RZ/G2L.

...

The following shows how to set the switches on the boot source selector:

...

...

1. Downloading the image
   Download the image (for example Debian) by running the following command on your Linux/Windows PC:

   Code Block
   wget https://solid-run-images.sos-de-fra-1.exo.io/RZ/Debian/rzg2lc_build/20231122-6391518build_date_20240529-git_rev_f22483f/rzg2l-solidrun-sd-debian-6391518f22483f.img.xz

   • For more Debian releases, please visit Debian Releases for RZ/G2L.

2. Writing the image to the SD card
   Use the following commands for writing the image to an SD card:

   Code Block
   xz -dc rzg2l-solidrun-sd-debian-6391518f22483f.img.xz | dd of=/dev/sdX bs=4k conv=fdatasync

   • For more information, please visit Flashing an SD Card .

   • Note:Plug a micro SD into your Linux PC, the following assumes that the USB-Disk / Micro-SD is added as /dev/sdX and all it’s partitions are unmounted.

   • Note: You can use the following command for writing to the SD in case you generated your own image:

     Code Block
     $ sudo dd if=/your/image/path of=/dev/sdX bs=4k conv=fdatasync

3. SD card insertion
   Please Insert the SD card into your device.

4. Power connection
   Connect your power adaptor to the DC jack, and then connect the adaptor to mains supply.

5. Power On
   Hold on the On/Off Power button - SW1 (as shown in the figure below)

   

   • Note: The system should turn on by default when the power is connected (without pressing the button).

6. Serial Connection
   Please insert the micro USB into your device, then you can refer to Serial Connection for installing necessary serial connection software in Linux/Windows.
   Once you installed the necessary serial connection software, you should be able to see the following:

...