SD Card
You will need to download an operating system for the HummingBoard RZ/G2LC | RZ/G2L | RZ/V2L and flash in to into a blank SD card in order to use the system. You can download official release distributions and find flashing instructions at our software page. If you need help to flash the SD card, please see our article Flashing an SD Card .
...
Boot Select
Before powering up the board for the first time it is recommended to select the boot media. In order to configure the boot media to please reference the below diagram :
| Info |
|---|
The black rectangle represents the switch position. |
...
When using HummingBoard Ripple & RZ/G2LC SOM
...
SD boot (Dip-Switch) [S3 = {1:off, 2:off, 3:off,4-5: N/C, 6:on}]
eMMC boot (Dip-Switch) [S3 = {1:off, 2:on, 3:off,4-5: N/C, 6:off}]
Serial Downloader (Dip-Switch) [S3 = {1:off, 2:on, 3:on,4-5: N/C, 6:off}]
When using HummingBoard Extended & RZ/G2LC SOM
<TBD>
When using HummingBoard Extended/Ripple & RZ/G2L SOM
<TBD>
When using HummingBoard Extended/Ripple & RZ/V2L SOM
<TBD>
Choosing the SD/eMMC device for the Linux from u-boot
...