...
Before powering up the board for the first time it is recommended to select the boot media. In order to configure the boot media, please refer to LX2160A CeX7 Boot Select <TBD>.the following DIP switch:
Boot media | Switch 1 | Switch 2 | Switch 3 | Switch 4 | Switch 5 |
SD | OFF | ON | ON | ON | X |
eMMC | OFF | ON | ON | OFF | X |
OFF | OFF | OFF | OFF | OFF | X |
The following shows how to set the switches on the boot source selector:
...
Booting from an SD card
The switches on the boot source SW1 selector must be set as follows:
Switch 1 | Switch 2 | Switch 3 | Switch 4 | Switch 5 |
OFF | ON | ON | ON | X |
The following shows how to set the switches on the boot source selector:
...
| Code Block |
|---|
load mmc 0:1 0xa4000000 ubuntu-core.img mmc dev 1 mmc write 0xa4000000 0 0xd2000 |
...
| Note |
|---|
Please Note: The above commands should be run only once (in the fist boot). |
...