...
The Clearfog Evaluation board has soldering pads for an ARM CoreSight compatible 10-pin header labeled U3014:
...
Connecting CodeWarrior
...
TBD.
TAP
Connector Orientation
The connection between JTAG and board must not swap any wires. Pin 1 on JTAG must go to Pin 1 on the Board to avoid damaging SoC and the JTAG device. See below the correct orientation for the CodeWarrior TAP to Clearfog EVB:
...
Connecting CodeWarrior Software with TAP
The CodeWarrior TAP can be connected either via Ethernet on the LAN or direct on a USB port.
On the LAN the tap acquires a DHCP lease and responds to hostname “FSLXXYYZZ” where XXYYZZ are the last 3 octets of its MAC address as indicated on the white sticker on the bottom of the tap. E.g. “FSL06BB1D” for tap with mac address “00:04:9F:06:BB:1D“.
Within the CodeWarrior Software the TAP is automatically usable when connected over USB. In case of Ethernet / LAN the hostname must be entered to the “Probe Address” Column of “Target connections” UI:
...